Comfast WIFI Extender Setup

Comfast Wifi Extender Setup is the best solution to all of your internet-related problems. They progressively boost your wireless network's signal and distribute it around your home. As a result, repeaters eradicate all dead spots in your home.

To set up your Comfast extender, follow the instructions below:

Unpack the Comfast range extender and connect it to the router.
To begin the configuration, wait for the wireless repeater's LED to illuminate.
Utilise any wireless device, such as a laptop or smartphone.
Navigate to your device's network settings and connect with the extender WIFI.
Now launch your web browser and type ap.setup into the address bar.
Type in the default username and password, Admin and password, and the Admin Repeater will scan all available signals and display them on the screen.
Choose the signal you want to repeat.
Enter your router's WiFi password.
Wait 10 to 15 seconds for your router and repeater to sync and connect.
You have just installed your WiFi range extender successfully.

Comfast WIFI range extender configuration with 192.168.10.1

Here are points that can help to you for you Comfast wifi extender setup via Wavlink extender default IP address are:

First, connect the Wi-Fi device to the COMFAST Ext network with the display XXXXX.
Open the web browser and fill in the IP address 192.18.10.1.
You have arrived at the Comfast WIFI range extender configuration page.
Enter your default username and password, "ADMIN" for both.
Choose Repeater on your PC/Laptop; this option will not be available on phones.
The repeater will automatically search for available Wi-Fi networks.
Choose the network that you want to improve.
Enter your home router or modem's password.
Wait 30 seconds for the settings to take effect.
You've finally finished installing the wireless booster.

Comfast wifi extender Setup with WPS method

WPS (Wi-Fi Protected Setup) is a network security standard that enables for the simple and secure setup of a wireless home network. It enables users to add new devices to an existing wireless network with no setup or configuration. WPS also adds a layer of protection by requiring a PIN or button-based authentication.

Here are some steps for Comfast wifi extender setup via wps method are:

Position the Comfast booster near the primary Wi-Fi router.
Press and hold the Wireless Protected Setup (WPS) button on your repeater for around 10 seconds.
Now, press and hold the WPS connection button on your modem or router.
The modem and wireless booster are establishing a connection, as indicated by the WiFi signal's blinking blue LEDs.
Once your device was connected successfully. The Comfast Wi-Fi repeater hitch attachment is known as Home Network PLUS.
As a security measure, you will only be asked to enter your password once.
Place your repeater wherever you like now that it is fully functional.

If you face issues while installing your booster. Don't worry; our experts are available around-the-clock to resolve any extender-connection issues.

Comfast extender Firmware update

Firmware is a software programme on a physical device that performs functions such as basic input/output chores and provides instructions for the device to interface with other computing devices.

Launch a web browser on any device that is linked to the extender's network.
Log in by opening the extender page.
Tap the Menu icon when it appears in the browser.
the firmware upgrade page will be launched:

Just select Settings, followed by Firmware Update.
If that option isn't available, pick Maintenance and then Firmware Update.

Now, click Check Online to see if any adjustments have been made.
Follow the guidelines to update the firmware on your extender whether a new upgrade is available.

How to set up my Comfast WIFI range extender in repeater mode?